Installing window blinds is just like most DIY jobs, but there are basic things that everyone must adhere to. 

Home design pros want you to take your windows and décor to the next level with new blinds Adelaide. Installing them is not too difficult, but its an undertaking that takes a little more time than other DIY projects. Hanging up blinds is a lot easier than you might have thought. There are just some general tips to follow when hanging them, and theres nothing special that needs to be done for your particular model of shades.

When buying blinds, youll need to figure out if you want them mounted inside the window frame or outside the frame. Make sure that your purchase corresponds with which mount style is best for your needs and measurement of how long they should be.

To ensure your installation goes smoothly, its best to have the essential items handy before you get started. A pencil helps mark where brackets will be positioned, and a level can help make sure everything hangs straight on the wall.

Interior designers remind you that when trying to measure a window, it can be difficult and frustrating. But some things may help. For example, if the top of your blinds is too high for you to reach comfortably without toppling over backward, having a stepladder on hand might come in handy. Having exact measurements will make measuring easier as well — so keep either a flexible metal tape or one with centimetres marked up along its length close by when measuring windows.

The position of the headrail is essential when you are installing blinds. You should place it at a fraction above your window casing to ensure that theyre not too short and dont hang off the ledge by accident.

Its essential to centre the blinds Adelaide with your windows and make sure that they extend an equal distance on either side of them. With inside mounts, be careful not to let the fabric rest against any part of the casing around your window because this may cause damage over time. Grab the pencil to measure the length of a blinds headrail. Put it at one end and make marks on the top, bottom and outside edge. If you want it to be perfect, then hold up this level and try holding the blinds straight while making these markings for accurate measurements.

With the pencil marks you made earlier, position one end bracket even with them. The opening of the end bracket should face towards to middle of your window. If everything went right and followed instructions so far, there will be a door on it that opens outward from its front side for easy access to screw holes in panels around your window frame.

To mount brackets to a wall or window casing, use a power drill and pilot holes. Use the right size of bit for your screws, so they go in smoothly. If you are screwing into wood, then no anchors will be needed but if not using wooden material like drywall or plaster, place an anchor before installation with screws.

You will need to raise them and insert the headrail into open brackets to attach the blinds. Once this has been completed, close both doors of each bracket at the front endpoints. The slats should snap closed from there on out—but if not, then twist the plastic wand with one hand while holding it in place with your other hand for opening or closing use only as needed.